Want to Buy Ms201tc handle

[Hallrdave]

looking for a Ms201tc mtronic handle. Looks like a tree was dropped on the saw I just picked up.

Thanks

 

[shortfuze82]

Your wire harness inside the old handle ok to swap over ? If so I have a used complete handle assy that has a short in the wire harness I would sell for 50 shipped

 

[Hallrdave]

Interested. You got a pic? Thanks

 

[shortfuze82]

As I said prior you will need to transfer your wiring harness the harness in this handle was shorted an created intermittent running and shutting off problems hence the reason the harness is clipped off to prevent it from being acadentially used again not knowingly

 

[shortfuze82]

Handle will be on its way tomorrow buddy

 

[Hallrdave]

Thanks again. Now I gotta find where I put the box of everything and hope I can remember how to put it all back together.

 

[shortfuze82]

If you have trouble don’t hesitate to message me I’ve built an repaired hundreds of them just once your done pay close attention to how they idle, the solenoid valves are notorious for going bad on them and most times still to this day most dealers won’t tell you this but it is part of the emissions fuel system so it carries an extended warranty. I’ve warrantied saws from as far back as 2014 already an they still pay the claims!

 

[shortfuze82]

It’s the least Stihl can do since their still having the same problems after 5 years! Also if you do end up replacing the solenoid valve also replace the existing fuel filter with the newest updated 0000 350 3522 higher micron orange filter it will make the new sol valve last longer and give it a fighting chance. The saw is no 200t but it will not disappoint you as long s you keep the chain sharp. Just a few tricks of the trade buddy