Ms880 repair

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Has anyone monitored cylinder temperature on these I am breaking mine in and it looks like it is running about 245 f in the cut and idols at 180 f does this sound about right?
 
So now that I have time again I am trying to dial in my saw. I have H and L screw out 1 turn it is idling at 2750 WOT is 7500 rpm I start turning in the H screw at about 3/4 turn I am at 8300 rpms. This is a brand new WG-13 carb. Does this seem like I am having to move the H screw too much? Has anyone seen this? At 8400 it’s starting to sound decent and cut decent but it could definitely use a little more kick. Does anyone have any experience with this?
 
Back
Top