put 5 psi air pressure in the oil tank with it running, see if that primes it, plugged vent maby?
Those 3400's dont pop up very often.
The mac and 3400
Sent from my LM-G820 using Tapatalk
I had that mac down to the bare block twice to get it right..it became a matter of pride.Cool man pretty sought after those bows.
Pretty tidy old girl too
Well done on the 600 series Mac even the die hard Mac lovers get beaten by them sometimes.
I had that mac down to the bare block twice to get it right..it became a matter of pride.
Sent from my LM-G820 using Tapatalk
Just that one. Got a 250 in a box, both crank bearings are knocked apart..crank is probably bad.Hahaha determined man any other Mac's?
Just that one. Got a 250 in a box, both crank bearings are knocked apart..crank is probably bad.
Sent from my LM-G820 using Tapatalk
Years ago i had a G70 and a 10-10E. Getting parts was tough...gave both away
Sent from my LM-G820 using Tapatalk
10-10S was the last one I worked on and Im in it deep. Probably $300. And I still need a muffler cover.
G70 needed a complete recoil and carb kit...Can be tough. This forum is invaluable to keep them running. I have 10 that will run and only 2 that gave there lives for the others.
How did that g70 go?
Just make 1
G70 needed a complete recoil and carb kit...
Sent from my LM-G820 using Tapatalk
I started it with a drill and primer fuel after i redid the points once.Aww did ya never run it?
Quite intriguing a small gear drive. The did a 54cc too
Enter your email address to join: