If anything your bar should sag less because the weight of the saw will tend to counteract the bar sag.Thanks bob! Will the bar wanna bend with the weight of my 075 if I don’t bolted to the saw like yours?
I’m not sure what bearing your talking about. I like the oil drain plug. How is that held in place?
If anything your bar should sag less because the weight of the saw will tend to counteract the bar sag.
Bolting the bar to the "bar bolts" makes a whole mill/saw more rigid which helps with finish.
I made a helper handle for my small mill when it use conventional clamps but I' never used it - I dont like anyone around the mill while I'm milling.
View attachment 729065
Seems my mill works ok on it. This has a full comp square chain on it. It’s a rough slab. Maybe I was pulling to hard. Man this saw has torque. Felt like I was at 1/4 throttle lol. I may be good with this one actually. I’m just going to add steel spacers under the clamps to add clearance like bobs mill. I made some skates for under the aluminum plate out of delrin it’s about 5” wider on each side. Ran out of gas on me tho , fuel filter wasn’t in the fuel. What do u guys do about the filter?View attachment 729100 View attachment 729101View attachment 729102View attachment 729103
Enter your email address to join: