Oregon guide bar recon kit ?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Den

Addicted to ArboristSite
AS Supporting Member.
Joined
Dec 17, 2015
Messages
1,003
Reaction score
535
Location
U.S.A.
Some years back, Oregon used to make a guide bar reconditioning/resizing kit. It contained a tool that looked like a large paint brush... had a V-section that slipped over the bar rails and various gauge spacers to fit in the slot.
You simply hit the back of the handle and re-sized the bar to bring the rails back into spec.
Anybody have the Oregon part number for said kit?

I remember seeing a post about this awhile back on A.S., but can't find it now when I search the archives.


.
 
It had a handle with a knob and taper outside with a bar groove spacer on the inside we hit the hammer to swage the bar rails to size. Made by Oregon can’t find it anywhere been looking.
 
There was a post on one of the chainsaw forums that went into specifics, like part numbers and things... I just can't find the post. For all I know, it might have been here on A.S.
 

Latest posts

Back
Top