ArboristSite.com Sponsors
 
 


RPM (tuning w/a tach)

Discussion in 'Chainsaw' started by White Lightning, Jun 9, 2009.

  1. White Lightning

    White Lightning New Member

    Joined:
    Dec 14, 2008
    Messages:
    4
    Likes Received:
    2
    Location:
    NY
    Hi All-

    I'm a bit of a lurker, but I am going to de-lurk and ask a question.

    So, I've graduated to tuning with a tach. It SEEMS the easiest base way of tuning with a tach is gett'er running near what feels good, then double check, and do again. BUT, it seems the extremes are pretty set in stone (on stock-ish saws). Aim for an idle of 2700s and then "book" value for max, outta wood...

    SO, my question is, what is the right 3 second max out of wood for the following:

    200t
    Muff modded 361
    Dual port muff 660
    and since I'm asking ht131

    Thank you in advance,
    WL

    re-lurk.
     
  2. computeruser

    computeruser Addicted to ArboristSite

    Joined:
    Jan 1, 2005
    Messages:
    6,732
    Likes Received:
    3,044
    Location:
    East Lansing, MI
    13k +/- for the 066 should do ya well. Not sure about the others.
     
  3. White Lightning

    White Lightning New Member

    Joined:
    Dec 14, 2008
    Messages:
    4
    Likes Received:
    2
    Location:
    NY
    Thank you. One down....

    For such an active forum, I am surprised that I don't have 101 dalmatians. No. Wait. 101 answers.

    Again, thank you for the reply.

    WL.
     

Share This Page