Saw has a clean piston and cylinder and pulls 150 on compression. Starts runs and oil but idle speed will creep up and down so there might be an air leak and I suggest it’s pressure tested before using it.
The starter cover has epoxy over the top bolt holes that has been done by someone else. I would assume the threads are stripped. It is holding tight but It should also be looked at.
Please ask any questions you may have. A
550 plus shipping obo.
PayPal F&F please.
The starter cover has epoxy over the top bolt holes that has been done by someone else. I would assume the threads are stripped. It is holding tight but It should also be looked at.
Please ask any questions you may have. A
550 plus shipping obo.
PayPal F&F please.