Eagle_Adam
Forum smart but 2stroke stupid....
Hey fellas,
Just got finished with a mild rebuild/repair on my 041AV.
Seen here:https://www.arboristsite.com/community/threads/thoughts.329109/
Soon as I wrapped up I fired up the saw without the B/C on just to see if I had succeeded or not. The ol girl fired up on the 3/4th pull and since it was 3am I left it at that. Well today when I put the B/C on and fired her up again I came to realize that something was amiss :/
I’m sure the terminology is wrong but I’m describing it like this. I the chain just will not accelerate to a useable speed.....
Vid:
I’ve double checked everything i did and touched during the rebuild & re-tuned the carb to the best of my abilities.
So here’s my question(s):
- did i do something wrong during the rebuild?(if I did, what was it?)
- assuming the rebuild was ok, then what’s up with the saw?
As always, thanks in advance for any and all knowledge/tips you may share!
Adam
Just got finished with a mild rebuild/repair on my 041AV.
Seen here:https://www.arboristsite.com/community/threads/thoughts.329109/
Soon as I wrapped up I fired up the saw without the B/C on just to see if I had succeeded or not. The ol girl fired up on the 3/4th pull and since it was 3am I left it at that. Well today when I put the B/C on and fired her up again I came to realize that something was amiss :/
I’m sure the terminology is wrong but I’m describing it like this. I the chain just will not accelerate to a useable speed.....
Vid:
I’ve double checked everything i did and touched during the rebuild & re-tuned the carb to the best of my abilities.
So here’s my question(s):
- did i do something wrong during the rebuild?(if I did, what was it?)
- assuming the rebuild was ok, then what’s up with the saw?
As always, thanks in advance for any and all knowledge/tips you may share!
Adam