-
If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.
You can become a Supporting Member which comes with a decal or just click here to donate.
Want to Buy Stihl .404 bar.
- Thread starter sross
- Start date
Help Support Arborist Forum:
wv311
ArboristSite Operative
I have a 25" GB titanium for stihl mount that id sell you. Its .404 and dont have much run time on it at all. PM me an offer.
Which mount?
wv311
ArboristSite Operative
I had it on my 460 and 660
I was actually directing that question to the OP. Are you needing a 3001, 3002 or 3003?
I believe that means you will need a large mount (14mm) bar. Most likely a 3002 mount per Stihl's designations. You won't be able to run anything that's a small mount (12mm) which would be found on almost anything smaller than your saw (066, 064, 056, 044, etc.).
The 3001 and 3002 are both large mount, but the tensioner and oil holes are in different locations. You will either need a 3002, or a 3001 that's been drilled to work on a 3002 mount saw.
