Transfer porting

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Justin Taylor

ArboristSite Guru
Joined
Dec 21, 2018
Messages
811
Reaction score
525
Location
Minnestoa
I have a scored 440 cylinder that I wanted to try something new on I just tried to add a Bridgeport let me know how I did thanks.
 

Attachments

  • image.jpg
    image.jpg
    1.7 MB · Views: 66
  • image.jpg
    image.jpg
    1.6 MB · Views: 67
I just started fooling with bridges and fingers, but I’m willing to toss out my thoughts.

The grinding looks nice and and the diagonal trajectory also. Depending how much room you have between transfer and ring end, I would try to start the tunnel closer to the intake side of the lower and stretch the upper with the top of the bridge. My thinking is that the corner of the lower will feed the bridge better and the whole point is to improve scavenging by increasing flow to the intake side.

I’m finding dual ring pistons to be difficult for bridges. A single ring with the land over the intake gives a lot more room to play with.
 
I don't usually make them that wide but that's not saying what you did is wrong or bad. I'm always concerned with case compression.
 

Latest posts

Back
Top