Walbro hda-137

[bigretic]

Hey guys.....found a saw in my fathers shed, an older Craftsman 3.3 which should be the same as a poulan 3300.Has anyone found a replacement carb for this?Or is rebuilding it the only way to go?
Thanks in advance!

 

[RedneckChainsawRepair]

HDA 49 the smaller carb is the one they use. Just rebuild IMHO. Not common for those to go bad. Just a rebuild kit. Check my # as just going off top of my head. K22-HDA

Most times it will be a cracked or broke impulse line too. Back of crankcase to top of carb. Replace it too.

You have the grey 3.3 or black and gold one or black and blue one.

I dont have the B/G one in a pic.

 

[bigretic]

Black and blue here!
Thanks again!

 

[RedneckChainsawRepair]

Black and blue here!
Thanks again!

Thats the good one IMHO.

Thread with info saved on those. http://chainsawrepair.createaforum.com/poulan/craftsman-3-3-sears-best/

Think I have about 5 of those now. They are my small saw that replaced the 346 550 353 etc etc.