What Oregon bar for CS-501 SX

[Greenerpastures]

Hi everyone
Just wondering what 18" Oregon or Carlton bar in .325 pitch by .058" gauge
would fit the Echo CS-501 saw.
I can not find any refferences other than to some 3/8 or .050" bars.

Thanks, john

 

[Deleted member 149229]

Yellow block at top of ad says .375 but item description states .325. You might have to call for clarification.

com

Carlton 18" Speed Tip Bar & Chain Combo (72 Drive Links) Clt 1801Wk272st / Wpl 28Rc72 | Carlton Speed Tip Bar & Chain Combos | Carlton/Windsor RSN Guide Bars | www.baileysonline.com

 

[Greenerpastures]

Yellow block at top of ad says .375 but item description states .325. You might have to call for clarification.

com

Carlton 18" Speed Tip Bar & Chain Combo (72 Drive Links) Clt 1801Wk272st / Wpl 28Rc72 | Carlton Speed Tip Bar & Chain Combos | Carlton/Windsor RSN Guide Bars | www.baileysonline.com

Hi Dahmer
That helps, I had a Carlton catalog from last year, did not see this in it, good to know.
I searched for Sugi Hara bars and found an Oregon refference K041, here, https://www.sugiharabarsuk.co.uk/product-category/group-3-echo-chainsaws/
When K041 is cross refferenced to Carlton it mentions the 10W Tailed Carlton type bars, so much check this too.
Mentioned elsewhere on lin are Oregon D179 and D176 tailed bars, nedd to dig deeper into this and see if its true, unlikely they both can fit, and also conflicts with K041 tail.

More comments welcome

Thanks & Regards, john