"wicked work saw" 385xp

[tlandrum]

heres the saw im working with

 

[bryanr2]

opcorn:

 

[tlandrum]

we can get started by getting all the port timing measurements.

 

[tlandrum]

after getting intake duration i figure how much i need to take off the base and then cut it

 

[HuskStihl]

I am very much looking forward to following this thread, and im sure my fellow 385 aficionados are as well, thanks!

 

[moody]

Excited to see this finished. Where could a guy get a degree wheel like that one?

 

[tlandrum]

the large degree wheel can be bought from jegs or summit

 

[tlandrum]

here is the lay out on the cylinder for porting

 

[Muffler Bearing]

How much??

 

[Muffler Bearing]

How much??

I got $350. Bucks

 

[tlandrum]

here we have the progress and finish on the intake side.i dont have to lower the intake becouse of lowering the cylinder to arrive at my intake duration , you can also see where i widened and squared up the intake side for more time area.

 

[tlandrum]

here are the progress pics of the exhaust side ,inside of cylinder. i have widened the exhaust and only raised it back up about the height of the bevel after lowering the cylinder for the intake and compression.

 

[tlandrum]

and heres the progress pics of the out side of cylinder exhaust and the finished shape

 

[tlandrum]

I got $350. Bucks

thats a good start to almost half way there :biggrin:

 

[Muffler Bearing]

thats a good start to almost half way there :biggrin:

Hell you got a 0 feedback rating _?

 

[Muffler Bearing]

I'm I going to get flamed-!!

 

[tlandrum]

better than a negative score

 

[tlandrum]

here are the upper transfers done

 

[Muffler Bearing]

[quot

 

[Muffler Bearing]

Dp