Would you run this?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Brent Adams

ArboristSite Operative
Joined
Jan 4, 2019
Messages
214
Reaction score
249
Location
Albertson GA
Stihl 019t.
Cleaned it up best I could. I used a 1.75x magnifier to look at it. You can see scratches there. When I go to just my 1.25x reading glasses, they are hard to see, and cant be felt at all. It looks like there May be one spot where plating came off on transfer divider, but it's below the compression chamber area.
Best pics I could get. Took through the magnifier.0210201708a.jpg 0210201709.jpg 0210201709a.jpg 0210201724.jpg 0210201724b.jpg
 
Transfer I can take care of.
Found some Scotchbrite wheels for the Dremel with the flex shaft. Cant use the acid, cause I'm afraid of the missing plating. Just wondered how it would hold up with the scratches. Saw wont be used commercially. Just for occasional limbing.
Meteor piston kit isnt expensive.
 
Yeah I wasnt gonna try to do anything with the piston.
I have cleaned about as much as I'm comfortable with in the cylinder. Worried about going thru the plating at the edges of the transfers.
 

Latest posts

Back
Top