1Maintenance1
New Member
Hello,
I have a McCulloch Double Eagle 50. Ran like a champion when I sent it out to get fuel lines replaced. Came back with wrong lines that did not seal in the tank. Not certain the are routed correctly. Found a similar pic posted here with designations but I'm certain they aren't correct for this saw. Running a ZAMA M-10 carb with 3 ports instead of 2. Post I looked at shows impulse line going to the top of the carb, but I know for certain that is not where it was when I sent the saw in. It was vented from the top. Noticed this when I cleaned the air filter. Also , both lines in the tank had fuel filters on them. Can anyone tell me the proper tell me the correct fuel line routing . Input would be very much appreciated. Thank you.
I have a McCulloch Double Eagle 50. Ran like a champion when I sent it out to get fuel lines replaced. Came back with wrong lines that did not seal in the tank. Not certain the are routed correctly. Found a similar pic posted here with designations but I'm certain they aren't correct for this saw. Running a ZAMA M-10 carb with 3 ports instead of 2. Post I looked at shows impulse line going to the top of the carb, but I know for certain that is not where it was when I sent the saw in. It was vented from the top. Noticed this when I cleaned the air filter. Also , both lines in the tank had fuel filters on them. Can anyone tell me the proper tell me the correct fuel line routing . Input would be very much appreciated. Thank you.