mill saw

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    Ripping chain/bar compatibility issues in Canada

    Hey guys, Have been poking around for the last hour or so on the site and haven't been able to find anything regarding this problem. I'll try to keep it short! I'm just getting started with chainsaw milling - recently bought a Stihl 291 MS, 18" bar. Calls for .325 - .050 - 74 chain. I have...
  2. caddguy

    2100 plus all milling rigging...considering selling...?

    I am considering selling my SCARR ported Husky 2100 with a 46" ish..panthermill II and 36"Orange GB Ti bar and 44xl GB Ti bar AND a 50" Cannon with all chains...oh and a pristine OEM 2100 cylinder and new Meteor 394 piston and rings....and a few other goodies. I am getting out of milling and...
  3. sweidish445

    288xp lite.. to squish or not to squish??

    A 288xp lite fell into my lap a few months ago. Had low compression so Im doing a cheap reconditioning.. new piston, ring, pin and bearing. I honed out the damage on the cylinder and did some modest work to the ports.. main bearings seem ok, so I'm not doing the complete teardown. I should add...
Back
Top