Want to Sell 372/268 custom machined pop - up pistons

[shortfuze82]

Had a few of these oem Gilardoni 268 open port slab sided pistons machined to fit the 372xp original edition saws. Ring, wrist pin as well as cir-clips included . I used a few myself with impressive results. now I’m willing to let a few go for those of you that do not have direct machinest connections these pistons were machined for .020” squish + -.003 “ if your intentions are to use these on an existing used cylinder please use some common sence clean carbon from squish band before installing , .010” of carbon build up across fire ring is not out of the ordinary for a used saw with a decent amount of hours . Machine work is clean with no interruptions. I’m not interested in trades of any kind . Thank you for your time. If you’ve never ran a 372 with one of these plug and play pistons bows your chance. Asking 75$ plus flat rate shipping 8$

 

[dap]

Had a few of these oem Gilardoni 268 open port slab sided pistons machined to fit the 372xp original edition saws. Ring, wrist pin as well as cir-clips included . I used a few myself with impressive results. now I’m willing to let a few go for those of you that do not have direct machinest connections these pistons were machined for .020” squish + -.003 “ if your intentions are to use these on an existing used cylinder please use some common sence clean carbon from squish band before installing , .010” of carbon build up across fire ring is not out of the ordinary for a used saw with a decent amount of hours . Machine work is clean with no interruptions. I’m not interested in trades of any kind . Thank you for your time. If you’ve never ran a 372 with one of these plug and play pistons bows your chance. Asking 75$ plus flat rate shipping 8$

Can you specify specs on these? Bore, what compression you saw with or without base gasket on new or used cylinder, etc

 

[shortfuze82]

These pistons MUST be used with a base gasket, on the builds I saw 175-180psi compression using oem cylinders

 

[shortfuze82]

Pistons are 50mm

 

[Sepia]

I assume you are only selling these locally - right?

 

[shortfuze82]

Ship anywhere in us

 

[old guy]

.020 ? I am running two at .040.

 

[shortfuze82]

.020 ? I am running two at .040.

372 stock squish is .038 not sure why you would want to run a .040 squish at that point better off leaving it stock

 

[old guy]

.020 ? I am running two at .040.

.020 ? I am running two at .040.

Ok, squish .020, I read it as .20 popup, my mistake!

 

[shortfuze82]

Yup squish is set at .020 +\-.003 the height of pop up you are correct at around .040 buddy .

 

[shortfuze82]

Previous 372 build using one of the above pistons

 

[vinpie1]

pm sent