395 cases with new tools

[Socalmisfit]

So I ordered some new cases for my 395 and got them yesterday, with my new Mattyo tool set. Tore everything down and put it back together in about 7 hrs. The tools are great, like having a helping hand when putting the cases back together. Very little effort is need when pulling the crank back through. I used a crescent wrench and they slid right back together. The tool set does cost some $$$, but if you work on your own saws is worth the investement.

The cases were on a saw I got for some work I did. I put a top end on it before but there were some stripped screw holes. When the top screw hole that holds the dog on stripped out it was time. This screw goes through the pto side case and screws into the flywheel side. Holds the front of the case together and it started to leak bar oil out the front. Just a little, but you could see it shortly after the screw let go. Fired her up and everything is SANO. Gotta run her through some wood and make sure everything is ok but, really happy with the tools and enjoyed the job.