• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Sold 48" Double End Milling Bar With 3 Chains for Alpina Saws

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Sawsrusinc

ArboristSite Operative
Joined
Dec 13, 2017
Messages
163
Reaction score
149
Location
Redding California
48 inch double end milling bar and 3 chains. The total length of the bar is 56 inches and was being used with 2 Alpina Forest 120 saws. The bar stud groves are right at 3/8" so I am sure it could be used or modified to use with different makes or models. The bar is nice condition on one side the other side has some pitting and could probably be resurfaced. The bar itself is straight no warping and the rails are in nice condition. It will come with three chains. The chains have not been used in over ten years and have some stiff spots but should loosen up with a good soaking or some cleaning.. I would do 200 shipped to anywhere in the lower states for the setup. Please PM me if interested, Thank you
 

Attachments

  • DSCN1634.JPG
    DSCN1634.JPG
    3.9 MB · Views: 11
  • DSCN1635.JPG
    DSCN1635.JPG
    3.9 MB · Views: 11
  • DSCN1638.JPG
    DSCN1638.JPG
    3.9 MB · Views: 10
  • DSCN1639.JPG
    DSCN1639.JPG
    3.9 MB · Views: 10
  • DSCN1640.JPG
    DSCN1640.JPG
    3.9 MB · Views: 6
  • DSCN1641.JPG
    DSCN1641.JPG
    3.9 MB · Views: 6
  • DSCN1645.JPG
    DSCN1645.JPG
    3.9 MB · Views: 7
  • DSCN1646.JPG
    DSCN1646.JPG
    3.9 MB · Views: 8
  • DSCN1647.JPG
    DSCN1647.JPG
    3.9 MB · Views: 8
  • DSCN1643.JPG
    DSCN1643.JPG
    3.9 MB · Views: 7
Back
Top