Mouthfulloflake
ArboristSite Lurker
PIcked this little clean saw up it was locked up.
opened it up piston and cylinder look great, crank bearings were rusty, I guess someone washed it?
oh well, ordered a chinese engine from amazon, looked decent bolted it all in.
cranked on the second pull idles and oils well, bogs when revved.
clean the carb, replace the fuel line, same.
order a new ( aftermarket) rubber manifold and that little white plastic ring.
remove engine again, install new manifold boot.
starts right up and runs perfect!
next day pick it up, and it starts right up, then wont rev starts bogging again.
what in the world am I missing here?
the one time it was running well ( after the new manifold) it was revving clean, and 4 stroking with bar and chain installed and held WOT.
I am stumped, sympathy and ideas are welcomed.
opened it up piston and cylinder look great, crank bearings were rusty, I guess someone washed it?
oh well, ordered a chinese engine from amazon, looked decent bolted it all in.
cranked on the second pull idles and oils well, bogs when revved.
clean the carb, replace the fuel line, same.
order a new ( aftermarket) rubber manifold and that little white plastic ring.
remove engine again, install new manifold boot.
starts right up and runs perfect!
next day pick it up, and it starts right up, then wont rev starts bogging again.
what in the world am I missing here?
the one time it was running well ( after the new manifold) it was revving clean, and 4 stroking with bar and chain installed and held WOT.
I am stumped, sympathy and ideas are welcomed.