Better connection

[Stonewoodiron]

Wondering what I should use to tie my 4 d ring saddle to the pulley. Right now , if I tie in to the oval biner I have no swivel. If I use the swivel biner connected to the oval, I swivel but I loose 5” of pulling space because I’m that much lower. Can’t a man be close to his Prusik AND swivel? Am I asking too much?!?! Haha. Any suggestions?

 

[Oldtoolsnewproblems]

Hmm, I don't have much experience and I hate to say "oh just throw some money at it" but the notch swivel is much smaller with it's gated connection, would that work for your setup? I have no experience with a 4d saddle, just barely missed my chance to buy one a little back.

 

[Stonewoodiron]

Hmm, I don't have much experience and I hate to say "oh just throw some money at it" but the notch swivel is much smaller with it's gated connection, would that work for your setup? I have no experience with a 4d saddle, just barely missed my chance to buy one a little back.

I’ll check it out. It’s a starting point at least. Had I known I’d be addicted to being in the saddle, I’d have done it a little differently.