• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Sold Cannon/Woodsman Pro Double Ended Milling Bars: UPDATE and PRICE DROP!

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Nov 17, 2017
Messages
727
Reaction score
900
Location
Lincoln University PA
I have 3 Woodsman Pro Double ended milling bars (Made by Cannon in the 90's for Baileys). They are all the same model #:

CDE--G1-50-63

CDE= Cannon Double Ended
G1= 14mm Bar slot
50= 50 inch length overall (effective cutting width is 38")
63= .063 gauge
All three bars have had use, but it appears to have been minimal to moderate at worst based on amount of finish left on them. There was some mild surface rust at a couple of the mount ends, and one has very slight wear on one rail side, but grooves look perfect and straight.
I am asking 225.00 each or 600.00 for all 3. I will ship in a rigid mailing tube, so that will factor into shipping cost. Paypal F and F please. CDE-1.jpgCDE-2.jpg
 
Back
Top