Double Eagle 50

1Maintenance1

1Maintenance1

New Member
Joined
Sep 5, 2020
Messages
2
Location
67501
Hello,
I have a McCulloch Double Eagle 50. Ran like a champion when I sent it out to get fuel lines replaced. Came back with wrong lines that did not seal in the tank. Not certain the are routed correctly. Found a similar pic posted here with designations but I'm certain they aren't correct for this saw. Running a ZAMA M-10 carb with 3 ports instead of 2. Post I looked at shows impulse line going to the top of the carb, but I know for certain that is not where it was when I sent the saw in. It was vented from the top. Noticed this when I cleaned the air filter. Also , both lines in the tank had fuel filters on them. Can anyone tell me the proper tell me the correct fuel line routing . Input would be very much appreciated. Thank you.
 
chipper1

chipper1

Living Life to the Full
Joined
Nov 5, 2014
Messages
36,714
Location
GR. MI.
Well shucks, I thought is was an ad for a colt lol.
Welcome to AS Mr maintenance.
This is the trading post where we buy and sell saws, it's a bit confusing.
I'll get a moderator over to move this to the proper place for you.
Good luck getting it running right.
@pioneerguy600 could you move this for him :).
 
1Maintenance1

1Maintenance1

New Member
Joined
Sep 5, 2020
Messages
2
Location
67501
Well shucks, I thought is was an ad for a colt lol.
Welcome to AS Mr maintenance.
This is the trading post where we buy and sell saws, it's a bit confusing.
I'll get a moderator over to move this to the proper place for you.
Good luck getting it running right.
@pioneerguy600 could you move this for him :).
Thank you. Sorry for the error on my part.
 

Latest posts

Top