Eco stalls after warming up.

[Smcgill]

Hello My Eco cs-306 starts and runs well until it gets warm, then stalls.
It does start , up but I have to keep my finger on the throttle, it will not idle.
What is my course of action to keep it running.
Thanks

 

[Paul Silvestri]

Air leak?

 

[Maintenance supervisor]

Bad ignition

 

[frank_]

my take is that it wont idle when warm ?
i would adjust the idle screw and low jet first, personally

 

[Smcgill]

Thanks
That's the info I was looking for..

 

[slimbo3006]

i would adjust the idle screw and low jet first, personally

My thoughts too. Although maint. supervisor is also on the right track with the ignition coil. When they start to go bad, they tend to go out when they get warm but will still work when cold. If you adjust the Low side on the carb and still have a no start when hot, check to make sure the coil is actually sparking. if no spark, let it cool then try again. if the spark returns when cold, then coil is bad

 

[Greaser007]

Air leak?

that is what I was thinking too, like maybe a split or loose fuel line.
The engine runs at idle but a no-go when needing more.
If saw won't revv much above idle, be sure to check the exhaust screen for blockage.

 

[lostone]

I would check the low adjustment screw, if you can start it back up and it needs you to hold the throttle to keep it running then I would guess that it's running to rich on idle and flooding out. If you find the low jet screw is set correctly then check the idle adjustment screw, next would be to check for a leak.