J-MAN
New Member
Gas, oil mix, and homelite ?
My Husky Manual show that i should be using 50:1 mix.
If i went to a 32:1 mix would this prolong the life of piston with the extra oil or am i looking for trouble.
I also have a question about the settings on a homelite saw how many turns for the idel speed and mix screws. i don't know the model. because i picked the saw up along the side of the road someone throwing it in the garbage. i took it home cleaned out the fuel tank, air filter and put a new plug in. Filled it up with new mix. and it took right off but want to die out i tinkered with the settings and got it idle but still not running good. I am sure this is the problem once i get it set it will be a good little saw. It has a 14" bar
My Husky Manual show that i should be using 50:1 mix.
If i went to a 32:1 mix would this prolong the life of piston with the extra oil or am i looking for trouble.
I also have a question about the settings on a homelite saw how many turns for the idel speed and mix screws. i don't know the model. because i picked the saw up along the side of the road someone throwing it in the garbage. i took it home cleaned out the fuel tank, air filter and put a new plug in. Filled it up with new mix. and it took right off but want to die out i tinkered with the settings and got it idle but still not running good. I am sure this is the problem once i get it set it will be a good little saw. It has a 14" bar
Last edited: