Help With Chipper Clutch Throw Out Bearing and Sleeve

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Tcooper02

New Member
Joined
Jun 28, 2020
Messages
1
Reaction score
0
Location
Arkansas
Hello all,

I have an old chipper (I believe it's a wood chuck) It has a Chrysler 318 Motor in it. The question I have is how the throw out bearing assembly works. I have disassembled it and it seems the sleeve with the bearing on it that disengages the clutch is too tight in the housing... am I missing something? I know my bearing that goes against the clutch release (fingers) is trashed and I need a new one. How easy should it be for these shaft to slide in and out of the pulley assembly?
 

Attachments

  • 20200629_110105.jpg
    20200629_110105.jpg
    1.4 MB · Views: 4
  • 20200629_110126.jpg
    20200629_110126.jpg
    1.3 MB · Views: 4
  • 20200629_110140.jpg
    20200629_110140.jpg
    1.2 MB · Views: 4
  • 20200629_110111.jpg
    20200629_110111.jpg
    1.1 MB · Views: 4
Back
Top