Homelite 995g - carburetor problems?

powerhomelite900g

powerhomelite900g

ArboristSite Member
Joined
Nov 7, 2019
Messages
53
Location
Germany
Good day chainsaw friends,
my completely rebuilt Homelite 995g causes problems in the idle ...
For information:
Newly sealed crankcase,
The two shaft-seals replaced,
Carburetor received new carb kit and was cleaned in an ultrasonic bath ...,
Many small parts such as spark plugs, gasoline filters etc. have all been replaced!

The problem:
The saw fluctuates in idle and dies after a short time.
This cannot be changed by settings, even if I set the idle very high, it still dies.
Even if I tip the saw to the side, the motor dies.
At full throttle there are no problems!

There are 2 videos in the following links below!

www.youtube.com/watch?v=vH-AAfDflUQ

www.youtube.com/watch?v=AHLXWf-Nwvk

I hope you can help me!
 
powerhomelite900g

powerhomelite900g

ArboristSite Member
Joined
Nov 7, 2019
Messages
53
Location
Germany
Yes, the saw only has one crank seal ...
I don’t think the saw draws air there, I just replaced the seal.
I will try to lean the saw in L again
 

Latest posts

Top