Good day chainsaw friends,
my completely rebuilt Homelite 995g causes problems in the idle ...
For information:
Newly sealed crankcase,
The two shaft-seals replaced,
Carburetor received new carb kit and was cleaned in an ultrasonic bath ...,
Many small parts such as spark plugs, gasoline filters etc. have all been replaced!
The problem:
The saw fluctuates in idle and dies after a short time.
This cannot be changed by settings, even if I set the idle very high, it still dies.
Even if I tip the saw to the side, the motor dies.
At full throttle there are no problems!
There are 2 videos in the following links below!
www.youtube.com/watch?v=vH-AAfDflUQ
www.youtube.com/watch?v=AHLXWf-Nwvk
I hope you can help me!
my completely rebuilt Homelite 995g causes problems in the idle ...
For information:
Newly sealed crankcase,
The two shaft-seals replaced,
Carburetor received new carb kit and was cleaned in an ultrasonic bath ...,
Many small parts such as spark plugs, gasoline filters etc. have all been replaced!
The problem:
The saw fluctuates in idle and dies after a short time.
This cannot be changed by settings, even if I set the idle very high, it still dies.
Even if I tip the saw to the side, the motor dies.
At full throttle there are no problems!
There are 2 videos in the following links below!
www.youtube.com/watch?v=vH-AAfDflUQ
www.youtube.com/watch?v=AHLXWf-Nwvk
I hope you can help me!