Husqvarna 570 with 575 top end

[Pioneer]

Meteor 575 piston/cylinder replacement on a 570 and the end result of this swap. A decent running saw so far, only about half an hour on it though and not making full power yet.
Was pretty happy with the quality of the kit, especially the cylinder plating.
Decent torque band and good revs considering the displacement, the 32 inch bar didn't seem to cause it to struggle too much.

Here it is in some good sized oak.

 

[Huskybill]

My two sons are running 570 saws they like them. We did change the mix ratio. Mine was a tad low on compression it got better with more oil.

 

[Fatherwheels]

Meteor 575 piston/cylinder replacement on a 570 and the end result of this swap. A decent running saw so far, only about half an hour on it though and not making full power yet.
Was pretty happy with the quality of the kit, especially the cylinder plating.
Decent torque band and good revs considering the displacement, the 32 inch bar didn't seem to cause it to struggle too much.

Here it is in some good sized oak.

Good work, nice running saw.

 

[Huntaholic]

Ive wore out a half dozen of those saws. You wont find a smoother running saw that's capable of commercial/professional use!

 

[RedneckChainsawRepair]

I had a brand new 570 I tested out for a bit when they were released. But comparing to my 365 special I knew the one that was staying and the 570 got sold.

If didnt have the 365 the 570 would have been fine though.