I thought we had a guide bar salvage discussion? But I'm as bad as an old bitty at using these forums...
Anyhow... I was all excited about this 16" McCulloch sprocket-tip bar for my "super" Mini Mac project...until I mounted it up, it's clearly bent where it mounts to the bar mount and a little separated. Who thinks I can bend this straight? Should I try to drill and spot-weld it back together?
Anyhow... I was all excited about this 16" McCulloch sprocket-tip bar for my "super" Mini Mac project...until I mounted it up, it's clearly bent where it mounts to the bar mount and a little separated. Who thinks I can bend this straight? Should I try to drill and spot-weld it back together?