• If you have bought, sold or gained information from our Classifieds, please donate to Arborsist Site and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Sold Jonsered 2166 project

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

RedTilDead92

ArboristSite Member
Joined
Aug 6, 2018
Messages
70
Reaction score
45
Location
Pa
This is a complete running saw, I bought it a few years ago and cut a couple cords of firewood with it. Recently I decided to get it off the shelf and look it over, I pulled the muffler and it has a carbon streak down the exhaust side of the piston. Saw also has a hairline crack in the case below the flywheel. I have no desire to fix it, asking $300 plus shipping PHO. PM me with any questions.20210817_173756.jpg20210817_173920.jpg20210817_173743.jpg20210817_173809.jpg20210817_173828.jpg20210817_173837.jpg20210817_174800.jpg
 
I was just planning on drilling a hole at the end of the crack and maybe supporting it with some jb weld and running it. It could be torn down and welded but I wasn't gonna get that involved.
 
Do you think it could be run with the case crack below the flywheel? Or do you think it should be repaired some kind of way or just replace that case half?
I would drill the end of the crack and run it. This saw is a cheap way to get into a good size saw.
 
Back
Top