fruitcakesa
ArboristSite Lurker
This is the same model saw as a Husqvarna 455.
Saw is well used for the DYI'er:
Brake handle is cracked
A top cover screw won't stay snug.
The duct tape was used to hold top on but currently 2 of 3 screws are holding.
20 inch bar.
Starts and runs but seems to possibly have a air or fuel leak of some kind in the fuel system: After starting and running, if you shut it off, it is very hard to re-start unless you hold the throttle wide open while pulling the starter handle.
Then it will run.
I have not removed the carb or inspected the engine but I suspect that it is something simple; a new hose, a gasket, tightening a fitting or cleaning the carb, would fix it.
I will ship but would have to check freight prices depending on zip code
Saw is well used for the DYI'er:
Brake handle is cracked
A top cover screw won't stay snug.
The duct tape was used to hold top on but currently 2 of 3 screws are holding.
20 inch bar.
Starts and runs but seems to possibly have a air or fuel leak of some kind in the fuel system: After starting and running, if you shut it off, it is very hard to re-start unless you hold the throttle wide open while pulling the starter handle.
Then it will run.
I have not removed the carb or inspected the engine but I suspect that it is something simple; a new hose, a gasket, tightening a fitting or cleaning the carb, would fix it.
I will ship but would have to check freight prices depending on zip code
