This saw is new to me. No history.
I move the lever to choke, when cold, pull about three times and the thing starts and runs (hi idle) on the choke setting.
Hot starts are fine using the run position. The saw runs and cuts like you would expect from a 271. The chain doesn't move when the saw is idling with the brake off.
I believe the carb limiters are still there. My low screw is 1.25 turns out. I have tried several low screw settings w/o any luck. I would like this saw to start as was intended. Suggestions, please.
Roy
I move the lever to choke, when cold, pull about three times and the thing starts and runs (hi idle) on the choke setting.
Hot starts are fine using the run position. The saw runs and cuts like you would expect from a 271. The chain doesn't move when the saw is idling with the brake off.
I believe the carb limiters are still there. My low screw is 1.25 turns out. I have tried several low screw settings w/o any luck. I would like this saw to start as was intended. Suggestions, please.
Roy