Well I dove head first into a port job on a ms460 that needed a complete topend. Went the hl supply route and bought a meteor cylinder kits (piston rings etc). However when I went to change the timing of the ports, I was chipping the nikasil like crazy, using carbide double cut bits at 10 on a dremel, even a grinding stone. It would also lift up with very little pressure as I tried to blend it in to the surrounding aluminum. Is there something I'm missing? Should I scrap it and try again; or run it and see- the blending extends a couple mm above the intake port so I'l a little concerned about that but being that it's not in the compression band it should be fine?
Also, looking to try out an Amazon cylinder "Harbot" 52mm kit- I hear it's made in the USA- is that true? Thanks!
Also, looking to try out an Amazon cylinder "Harbot" 52mm kit- I hear it's made in the USA- is that true? Thanks!