Partner P100 Not running when hot

[hotshot]

Simple press in, but could sparingly apply sealant if you wanted to.

Note the position of the old one, then drive the new one in with a plastic mallet.

 

[ozziechainsaw]

Awesome.
Had a quick look yesterday and it seems no one in Australia has it. I might have to order some from USA.

Regards

Justin

 

[cookies]

i wonder if you could find a threaded barb then tap the hole

 

[hotshot]

Your local Stihl dealers may stock an equivalent in Walbro, check there first. Try parts #s 1117-122-3900 or -3901.

 

[Vintage Engine Repairs]

Hey from WA In a worse case scenario if you can’t get a replacement barb, could a soldering iron melt it / plastic weld? I have done a fuel tank, but could it be worth a shot? Just don’t close up the ID ha

 

[CausticUC]

Hey from WA In a worse case scenario if you can’t get a replacement barb, could a soldering iron melt it / plastic weld? I have done a fuel tank, but could it be worth a shot? Just don’t close up the ID ha

? Not sure you would get far with a soldering iron.

One could try MEK on the plastic and lightly clamp it. As a last resort JB Weld would certainly be an option.

 

[ozziechainsaw]

Your local Stihl dealers may stock an equivalent in Walbro, check there first. Try parts #s 1117-122-3900 or -3901

I called the local Stihl dealer with the OEM Walbro number and they couldn't match it. But I am sure with the Stihl part number they shouldn't have any issues.

Thanks for those Stihl parts numbers

Cheers

Justin