Pferd guide bar dressing tool replacement files

[unknwn]

When I was assured by the seller I would get the blue dressing tool, and NOT a replacement file, I went ahead and ordered.
I ended up with a pile of replacement -coarse- Pferd file segments.
Is there enough draw here for me to list them on the site, or will sending them back be the best avenue?
I paid a good buck for a single Oregon replacement (fine-tooth) file segment, and have never even seen these available, so I thought to offer them rather than fall back on -return- which will result in their disappearance into a black hole somewhere.

 

[RedneckChainsawRepair]

You get the 10pk 13026?

 

[unknwn]

That's me !

 

[Philbert]

I liked the Oregon / STIHL / Valorbe bar dressing tool better than the Pferd. Post #72 shows my approach for affordable, replacement files.



https://www.arboristsite.com/community/threads/bar-dressing.315936/
Philbert

 

[unknwn]

One thing I can say about these Pferd file segments is that they are exceptionally sharp.
I just don't know what to expect about how effective they'll actually be on the guide bar burring versus truing up rails when compared to how fine the file teeth are on the genuine Oregon file tooling.
I can only suspect that the chinee copy of the Oregon file holder has nearly worthless file element (??) .

 

[Philbert]

I can only suspect that the chinee copy of the Oregon file holder has nearly worthless file element (??) .

I was not impressed with the one I received. Then, again, some guide bar rails may be softer than others.

Philbert