Sold Ported Husqvarna 61 266xp conversion

[NewEngland ChainSaw Works]

This is a great classis husky saw. This saw started life as a 61 but was converted to a 266xp with a factory cylinder caber ring and a high compression piston from the little red barn. Finger ports have been added to the rear of the cylinder. This modification really wakes these saws up. Also the ignition timing, transfer intake and exhaust ports have also been advanced. It has been serviced with a new fuel filter and seals. It does have a velocity stack and foam filter. I can change it back to the stock filter and black top if needed. The work is not extreme so it starts with a couple pulls and idles great. This saw absolutely HAMMERS! In the video is has a stihl bar 20 in. .325 bar and 9 pin sprocket. I have had this saw for years but it is time to let it go. Feel free to ask any questions

I am asking $500 shipped
Thank You

 

[zorak]

This is a great classis husky saw. This saw started life as a 61 but was converted to a 266xp with a factory cylinder caber ring and a high compression piston from the little red barn. Finger ports have been added to the rear of the cylinder. This modification really wakes these saws up. Also the ignition timing, transfer intake and exhaust ports have also been advanced. It has been serviced with a new fuel filter and seals. It does have a velocity stack and foam filter. I can change it back to the stock filter and black top if needed. The work is not extreme so it starts with a couple pulls and idles great. This saw absolutely HAMMERS! In the video is has a stihl bar 20 in. .325 bar and 9 pin sprocket. I have had this saw for years but it is time to let it go. Feel free to ask any questions

I am asking $500 shipped
Thank You

Would you be willing to sell it with out the bar? And what's up with the rivited plate on the top cover?

 

[NewEngland ChainSaw Works]

I just sold the saw on ebay