Replacement bars for Makita EA5000

[Mikey48]

Bought a new Makita 5000 that I mistakenly ordered with a .050 x .325. bar, and would like to get a .058 gauge bar (18") so that I can use chains from my old Jonsereds 49sp interchangeably and not have to keep them separate.
Can you give me bar mount information to locate what I'm looking for? Is there a bar specification chart available? Any help appreciated! [ The Jonsereds uses .325 x .058 x 72 ]

 

[Franny K]

They both use the same bar mount don't they? Have you compared the slot width and placement, the location of the adjuster holes, and the location of the oil input hole.

The pitch, gauge and drive link count as in [ The Jonsereds uses .325 x .058 x 72 ] is different than the bar mount.

https://www.oregonproducts.com/en/part-finder

 

[Mikey48]

Thanks for responding Franny K. I know, put that up in order to show the specs for chain matching.... finally found the chart I was seeking, and it's K095 mount for the Jonsereds & Makita.

K095*
Z095*
- Carlton mount - 01W
- Windsor mount - CJL

chart at https://www.lawnmowerpros.com/chainsaw/chainsaw-guide-bar-mount-chart.asp

 

[dboyd351]

yep
what they call small mount Husky bar