zdinks
ArboristSite Lurker
I currently mill with a MS660 on a 36" bar. I am getting hired to mill several logs in the upper 40" width range (ash, american elm, and red oak). I have a cannon double bar picked out and plan on using just the single saw with a helper handle for the time being (will also use an auxiliary oiler). I'll go as easy possible on the saw and will be using the grandberg winch for consistency. Is it a bad idea to mill a few logs with my 660 that are that wide? I want to use a chain with some level of skip. Can someone provide a link to the right skip tooth chain (0.063)? I can't seem to find much on different skip chains.