New here and hope I can find some help.
Hear is the history on the saw. I bought the saw not in working order but had good compression . I replaced the carb, fuel filter and line , new air filter, tank vent and hose, and spark plug. Cut 2 loads of wood and was very impressed with the power and ran it great. Next time out I was cutting a large pine and doing fine and then acted as if I ran out of gas. I checked the tank and was half full so checked air filter and not bad I then replaced the coil checked the plug. It will run great with no load but will only cut for about 2 minutes before it starts to bog and acts like its out of fuel. Fuel filter still look new, tried different carb, and gas is fresh. I have noticed the air filter does have some gas wetness in front. Any ideas?
Hear is the history on the saw. I bought the saw not in working order but had good compression . I replaced the carb, fuel filter and line , new air filter, tank vent and hose, and spark plug. Cut 2 loads of wood and was very impressed with the power and ran it great. Next time out I was cutting a large pine and doing fine and then acted as if I ran out of gas. I checked the tank and was half full so checked air filter and not bad I then replaced the coil checked the plug. It will run great with no load but will only cut for about 2 minutes before it starts to bog and acts like its out of fuel. Fuel filter still look new, tried different carb, and gas is fresh. I have noticed the air filter does have some gas wetness in front. Any ideas?