Jon1212
Riff Raff Fart Knocker from other Forum's.
It would appear so.....
Swap meet...
- Thread starter Four Paws
- Start date
Help Support Arborist Forum:
Hi Folks,
Looking for a choke rod and choke plate for Pro mac 610-650, timberbear etc. I can live without a chain break but one would be useful or at least some parts as i have the clutch cover.
Looking for a choke rod and choke plate for Pro mac 610-650, timberbear etc. I can live without a chain break but one would be useful or at least some parts as i have the clutch cover.
Jordan3605
ArboristSite Operative
looking for a 18" stihl rollomatic es or tsumura
3/8
.050
for a stihl ms362
paypal waiting
3/8
.050
for a stihl ms362
paypal waiting
iwannachopwood
ArboristSite Member
im looking for a coil or a few coil spark plug wires for a mac 10 10 600014E
Jordan3605
ArboristSite Operative
Need a cylinder for a ms441...
I have an AM full wrap for a 066 that I'm not using.
Pm sent
Need some PM Redhead parts, fuel tank, carb, right side cover.
Looking for a blown up MS210C EasyStart with a good coil and flywheel..., actually just the coil and flywheel but will take a whole saw if that's easier.
tmessenger
ArboristSite Guru
I need a good 028 oil pump with the drive gear (don't need the small one that the clutch drives) the plastic pump cover, the long double row needle bearing for the clutch hub and the bell shaped washer that holds the chainbrake handle on the starter housing side. Shipping would be to Iowa 52556.
Thanks Tim
Thanks Tim
vw_motorsports
ArboristSite Guru
need a good fuel tank for a stihl 084
lumberjackchef
Addicted to ArboristSite
"good" not a beauty queen im sure but I may have one, dont know its condition. I will go dig it iut and take a look.....
Sent from my moto e5 play using Tapatalk
Need a good tank handle for an stihl ms460.
Have stuff for trade,used parts, some new, cash, this and that.
Have stuff for trade,used parts, some new, cash, this and that.
Get an AM one and swap the OEM controls onto it.
I've experienced poorly sealed seams in AM tanks. Pressure test them with a fair amount of pressure before committing one to a build or replacement.
Must be bad batches. I've used 3 460 tanks w/o issue and only may of had a problem with one of 5 440 tanks (never figured what was wrong, but just swapped it out to fix it). It may have been the vent or fuel line.
What supplier has worked best for you?
Direct from Huztl has worked, and also a supplier who already had them in the US. Be careful, I got several (from different venders) 440 tanks instead of 460 tanks.
I don't remember the US vender, and I have to leave in a few minutes, will be gone all day.
I don't remember the US vender, and I have to leave in a few minutes, will be gone all day.
Similar threads
