Will a 0.05" gauge chain fit a 0.43" bar on my Husqvarna 120i?

[wahoowad]

I picked up a spare chain for my Husqvarna 120i when I bought it a couple years and recently installed it. Today I grabbed the box to order another and noticed the box said it was a chain type H38 / Pitch 3/8" / Link 52 / Gauge .050". but the Husqvarna site says my saw uses H38 / Pitch 3/8" / Link 52 / Gauge .043". I don't know if the saw shop used the wrong box or if I actually got the wrong chain. I'm guessing it wouldn't fit in the bar groove but I don't really know. I used the saw+chain a good bit this week to limb up downed trees and it cut great.

 

[J D]

Post a pic of the markings on the bar. If your new chain isn't binding (ie you can freely move it by hand when lightly tensioned on the saw) you probably have an 0.050" bar or a very worn bar groove

 

[wahoowad]

 

[IthacaMan]

I searched that number and this came up. I think your bar is .050 acording to this. https://www.arboristsite.com/thread...cludes-oregon-91vxl052-chain-25.319217/page-2

 

[J D]

[HUSKY1] 501 95 92-52 Husqvarna 14″[35cm] Bar 3/8 Lo Pro .050 52 drive links