I'm a little confused here, the pic here shows the fuel line I just pulled out of my MS200T, but as far as I can tell its the wrong one. Here's what happened - I'd not used it in years, and now the grommet section popped out of the fuel tank wall and I managed to poor gas all over the table before I noticed. I've tried everything to re-seat the grommet, but whatever I do, the slighted touch and it pops right out again.
As a disclaimer, it's possible I replaced the line with the wrong one something like 10 years ago, but honestly I don't remember now. It looks like a 1128-358-7701, and I think I need the 7705 as it's an early version of the ms200t, like 20 years old.
If anyone has advice on this I could use the guidance.
As a disclaimer, it's possible I replaced the line with the wrong one something like 10 years ago, but honestly I don't remember now. It looks like a 1128-358-7701, and I think I need the 7705 as it's an early version of the ms200t, like 20 years old.
If anyone has advice on this I could use the guidance.