Tothemax
ArboristSite Operative
- Joined
- May 22, 2014
- Messages
- 400
- Reaction score
- 123
Hey guys. I posted this in another area but I am not getting any hits so I figured I would try here.
I have 2 husqvarna k760's with brand new piston and cylinder kits on them. One runs like a raped ape. It throttles up from idle to high rpms with no issues. The other one seems to have a lag from low to high rpms. It will hit a wall for a few seconds and then hits the high rpms.
What would cause this? Carb looks great. The fuel filter is new, new air filter, new Oregon plug, etc.
The only difference between the two saws is a serial number break. Both saws required different cylinder kits. The difference looked to be in the intake. I had to measure the intakes on both and there was a difference there.
I have 2 husqvarna k760's with brand new piston and cylinder kits on them. One runs like a raped ape. It throttles up from idle to high rpms with no issues. The other one seems to have a lag from low to high rpms. It will hit a wall for a few seconds and then hits the high rpms.
What would cause this? Carb looks great. The fuel filter is new, new air filter, new Oregon plug, etc.
The only difference between the two saws is a serial number break. Both saws required different cylinder kits. The difference looked to be in the intake. I had to measure the intakes on both and there was a difference there.