Sold NOS Oregon 29" Bars

[mikerudder]

Any of these left?

Yes I have about 15 now I believe.

 

[mikerudder]

UPDATE
Will do $50 plus actual shipping cost.
Shipping these things aren't cheap, and I have seen costs from $25 on the West Coast, and up to $50 to the East Coast
Trying to be as fair as I can on these.
Shipping has gone crazy.

 

[mikerudder]

Bump

 

[Jay Hansen]

UPDATE
Will do $50 plus actual shipping cost.
Shipping these things aren't cheap, and I have seen costs from $25 on the West Coast, and up to $50 to the East Coast
Trying to be as fair as I can on these.
Shipping has gone crazy.

Pm sent

 

[nstueve]

So it's darn close to a big stihl mount bar. So would an old 10mm jonsered d024 mount work with 2mm spacers or an adapter. And obviously a little oiler hole modification?

You’d need 2mm wide material on both sides of the stud. You’re needing to upsize by 4mm total. You can get a strip of 2mm thick material and heat it with a torch and then wrap your studs in an “S” pattern and you’d be done.

2mm = 5/64in

 

[Bill G]

You’d need 2mm wide material on both sides of the stud. You’re needing to upsize by 4mm total. You can get a strip of 2mm thick material and heat it with a torch and then wrap your studs in an “S” pattern and you’d be done.

2mm = 5/64in

That would work or just use the Cannon big mount adapter

 

[Steve1984]

Sent you a PM

 

[mikerudder]

Sent you a PM

Replied

 

[Dadsaws]

Got any more bars?

 

[nesT]

UPDATE
Will do $50 plus actual shipping cost.
Shipping these things aren't cheap, and I have seen costs from $25 on the West Coast, and up to $50 to the East Coast
Trying to be as fair as I can on these.
Shipping has gone crazy.

PM sent Mike, if there's any left.