Search results

After New carb, lines and filter and it runs like a new one. Thank yall for the help. Much appreciated!

Thanks guys for the info! i got ahold of him and he is looking into it. Thanks alot!

Hello all, i had this in the large equipment forum and it didnt seem to gain any interest there so ill try here......Replacing the carb on my dads horse tiller. From what i can tell its about a 1982 model horse II. While working on it i noticed that the tube that runs back to the tines can turn...

Replacing the carb on my dads horse tiller. From what i can tell its about a 1982 model horse II. While working on it i noticed that the tube that runs back to the tines can turn a little bit meaning if i grab the tines ( tines cover is off) i can rotate that whole unit. It rotates right where...

New oem carb is ordered so its getting new fuel lines,filter etc. will let you know the outcome and i will look at the old carb when i take it off and see whats up. Thanks alot guys!

Thank you! I ran through that procedure again and it started briefly with an empty tank and the carb purged. Think it points to carb. After that i put fresh gas in and immediately flooded. What do you think? Again thanks.

Also the primer refills very slow.......

Yep i cleared the cylinder of fuel and pulled it to get the rest out. I also pulled the muffler and checked spark screen all good there.......

Gmornin all, just got an fs80r trimmer to fix. Wont start, not even try. Cold compression is 115 psi. Good blue spark and there is raw gas coming out the muffler and plug gets wet. Start with a carb rebuild? Is 115psi low for this trimmer? Where would you guys go? Thanks

And yes there appears to be a small pin missing. Looks like it fits in the crankcase and rides in the oil pump gear. Sound right? Im afraid with that broken plastic toward the back that the pump wont have support back there and fail prematurely

I will check. Was told the saw ran fine just didnt oil and bar oul just ran out of it

Anybody?

Working on a husqvarna xtorq 440 oiler. Looks like the area toward the back of the saw that supports the oiler has been wallowed out. Is there a fix for this? An upgraded oiler? Part numbers? Thank you. Im not sure a new one is going to work for long.....

Thanks guys. A friend saw it in a thrift shop and showed me. So what would it be worth?

Can anyone id this saw and what would it be worth? I saw it and thought it was neat. Thanks in advance for the help!

Looking for an ms260 tank handle with flip cap. Going on a new saw so im looking for a clean or new one thanks! Sent from my iPhone using Tapatalk

Thanks for you guys help, wow I posted this a few years ago. Think I ended up replacing powerhead, I replaced carb with new still no go (even put the carb on a working trimmer and ran fine), checked fw key seals, replaced coil etc. That one whipped me I guess.....

Ive looked at the knock offs, may try one out but was hoping to find a oem one

Looking for a MS260 clutch cover thats in nice shape, doesnt need to be perfect just something thats not beat up or worn out. Thanks Ryan