N1ST
ArboristSite Lurker
I was cleaning the saw today. I took off the air filter and looked inside the neck of it. I was surprised to see dirty dust type stuff that accumulates on the outside of the saw. Anybody else notice this? Either dirt got in thru the filter screening (seems unlikely) or where it meets the carb tube (doesn't seem like it's a very tight fit). The saw has about 15 tanks of gas thru it.
Side note: I was dissapointed to see that the husky maintenance pack that has an air filter, gas filter, plug, and oil - supposedly for the 346xp - has an air filter that doesn't fit. After cutting off the extra tabs, the neck is too short and fits on too loosely. The number of it also does not match the original filter's number. Arggg.
Side note: I was dissapointed to see that the husky maintenance pack that has an air filter, gas filter, plug, and oil - supposedly for the 346xp - has an air filter that doesn't fit. After cutting off the extra tabs, the neck is too short and fits on too loosely. The number of it also does not match the original filter's number. Arggg.
Last edited: