Popup vs Flat Top?
- Thread starter Mastermind
- Start date
Help Support Arborist Forum:
Trx250r180
Saw polisher
seems to hold the rpms in the cut pretty good with that baby bar 
Mastermind
Work Saw Specialist
It wasn't so impressive with the 28"......
Hedgerow
HACK
Brad your camera's sensor has quite a few bad pixels, right in the center. I couldn't read your tag.
KenJax Tree
Terraphobic
Hell i've been doing it backwards
Trx250r180
Saw polisher
Mastermind
Work Saw Specialist
I hear ya Brian.......gotta remember though......
That ain't no wimpy piece of cedar.
Hedgerow
HACK
And there was smoke coming off the bar tip...I hear ya Brian.......gotta remember though......
That ain't no wimpy piece of cedar.
Jon forget to put bar oil in it again??
Seems to take a hang up without stalling out..
Sounded pretty lively..
Mastermind
Work Saw Specialist
It's was raining a lot more than it looked like.
Trx250r180
Saw polisher
I hear ya ,not rotten either ...........I hear ya Brian.......gotta remember though......
That ain't no wimpy piece of cedar.
the other half was not drug out yet
Looks pretty strong, should do real well with a 24" bar, save the 28" for the 046!
My next M/Mind saw is gonna be a new 441R-cm. l think its a model that the monkey has a fine recipe for and does particually well. So you end up with a super smoothe saw with silky smooth AV, foolproof Mtronics, top air filter and 70cc's of monkey porded madness!! What is not to like about that!!
Randy said: "It wasn't so impressive with the 28"......"
I think U been runnin that 661 too much!
Next time, test it after U work on a 261!
I think U been runnin that 661 too much!
Next time, test it after U work on a 261!
Mastermind
Work Saw Specialist
Just trying to be realistic.
It was so impressive with that 20, that I expected more with the 28.
Trx250r180
Saw polisher
Want me send you a chunk of rotten cedar ?,i still have 4 feet off that bad end laying next to the mill area lol
Gypo Logger
Timber Baron
Randy, nobody on the Rescue Thread can figure out what FHC means.
Could you help us out?
Thx
John
Could you help us out?
Thx
John
Mastermind
Work Saw Specialist
Want me send you a chunk of rotten cedar ?,i still have 4 feet off that bad end laying next to the mill area lol
Brian......you are a true and dear friend.
Mastermind
Work Saw Specialist
Mastermind
Work Saw Specialist
I'm gonna get banned.......again.
