My 576XP won't oil as it should. I have the oiler turned all the way up as I am running a 36" bar and chain on it. Is there something clogged in it ? Oil tank is full of synthetic bar oil and still having problems with it. Suggestions ? Solutions ?
Check your bar, then the tank vent, your worm gear and if nothing change, the oil pump.
True but this 576XP has some motor work done to it and it screams! It doesn't have a problem turning it, it's just oiling it.
i agree 100%,, sure it might pull it good but the saw is not set up to put enough oil out for that long of a barI had no doubt about that, but the oiler may not flow enough toi oil this kind of bar.
I have never done this so I can not confirm or deny if it will work, you may be able to change the worm and the pump gear out with one from a 390? I have though about this for use on my 2071 for use with a 32" bar for rare use.
Jeremy
Enter your email address to join: