Aaron,
You're my hero.
Pictures of the mount area, and measurement of the bar studs might be helpful.Would anyone know if a 1468-88 Sandvik Bar would use the equivalent D176 mount? That bar fits old homlite saws and was told it would fit my old solo 60135 (635) but its also hard to find. So I am trying to figure out a current or more common tail mount to be used on this saw.
I'm not up on bar mounts. I just try a few till I find one that works.
If your trying to fit a bar to the old Solo you will need to know the
diameter of the studs. Most likely they are 10mm. I would look at
Bars from Dolmar, Husky, etc that have 10mm slot. You could find
a bar with 3/8 slot like most American saws but you will need to file
the bar slot. Then there is the adjuster hole and oil hole.
Yes. You could also take a Windsor EM mount and open the slot a 0.5mm. This will also work with other mounts such as a D196.They do measure 10mm so are you saying that a D024 is likely to fit?
Enter your email address to join: